Sawmill Blade Guide Rollers 1-1/4" Blade Bandsaw Homemade MILL 1/2" Bore Bearing

Description

Homemade Sawmill or Bandwill Blade Guide Roller  1/2" Bore
****For use with 1-1/4" Sawmill Blade****
Be sure these are what you need before buying. We are not a testing operation..we are selling you what you see in description/pictures..If a return is opened, shipping is not a covered item and a RESTOCKING FEE  may apply..??????
If you are building a homemade sawmill. These rollers are a must to help keep the blade in place while cutting
Qty-2 Rollers and 4 Bearings       blade not included
**** Manufactured right here in Texas ****  CNC Machined
I take a piece of 1018 round stock and use a CNC mill & turn it down to the following sizes..
No mounting hardware.. you are buying just the roller guides and  4-Press fit bearings (not installed.). Bearing number will be on side of each one.. and they are easy to replace when necessary. tightened bolt keeps bearings compressed, no snap rings to deal with
Roller Guide weighs app. 1.4 Lbs..My guide is designed to help keep vibration down during operation
blade are for illustration purposes only and not included
press fit design
Designed for 1-1/4" blades only
Sealed bearings
Just under 1-3/16" across widest point of roller guide (Front to Rear)
App. 15/16" wide/deep where blade rides on pulley
2-1/2" wide Overall back flange diameter
3-Grooves for dust partical clean out
Flange at rear is app. 1/4" wide
Diameter of pulley where blade rides is app. 2"  (outter diameter)
all sizes may vary a little..and are approximate
Bolt/shaft size for bearings 1/2"
Double sealed bearings..
1/2" spacer may be necessary when installed, depending on your set up..Not included
If you have any questions.. Drop me an email.. I plan on machining some for the 1-1/2"  blade next
Check out our sawmill builds on youtube under Larry Sbrusch
C30
If you need more than one of these , visit my store under industrial section..Normally these sell out just as fast as I can machine them..